"This web site is secured using a thawte Digital Certificate. This ensures that all information you send to us via the World Wide Web will be  encrypted. Please click on the thawte Trusted Site Seal which demonstrates our commitment to your security."
|
|
Roller Shades
- Spring Roller System Installation
|
|
BRACKET
PLACEMENT:
To determine where to mount your brackets simply
hold your roller shade up to the window (shade should
be completely rolled up) in the desired location.With
a pencil, make a mark where each "tip"
of the roller lines up with the wall.The slot and
the hole in the brackets.
MOUNT THE BRACKETS:
Standard Roll
(Fabric falls from back side of shade.)
1. Mount brackets in desired location.The slotted
bracket is mounted on the left side.
Reverse Roll
(Fabric falls from front side of shade)
1. Mount brackets in desired location.The slotted
bracket is mounted.
INSTALL THE SHADE:
1. Place the round pin in the bracket with the round
hole and place the flat pin into the slotted bracket.
(see fig. 1) for inside mount and fig. 2 for outside.
|
|
ADJUSTING
TENSION ON THE SPRING ROLLER:
1. If you desire more tension, pull the shade down
half way and remove from brackets. (see fig. 3)
2. Roll the shade up by hand. (see fig. 4)
3. Replace the shade into the brackets.
*If you have to much tension, remove the shade while
it is in the up position and unroll half way by
hand and replace the shade into the brackets. Note:
too much |
 |
|
|
